EasyManua.ls Logo

NEC UNIVERGE NEAX 2000 IPS - Page 175

NEC UNIVERGE NEAX 2000 IPS
1038 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
– 151 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
LAN INTERFACE ASSIGNMENT
0A
IPT INITIAL
IP-PAD INITIAL
SIP INITIAL
: Initial Data
Y 1ST DATA 2ND DATA
No. MEANING DATA MEANING DATA MEANING
75 DTMF inband mode for
PN-8IPLA (IP-PAD)
[Series 3300]
00
31
LAN Interface
number
0
1
In-band mode (Voice pass
through)
Out-band mode (with H.245 UII)
76 Provide the call log collec-
tion with the PN-8IPLA
(IP-PAD)/PN-8IPTA (SIP)
[Series 3500]
00
31
LAN Interface
number
0
1
To provide
Not provided
NOTE: When changing this data of IP-PAD accommodated in a remote site, execute the office data copy by
CMEC Y=8 to the remote site.
77 Provide the fault log collec-
tion with the PN-8IPLA
(IP-PAD)
[Series 3500]
00
31
LAN Interface
number
0
1
Not provided
To provide
78 Tone Disabler for the FAX
communication on the SIP
card
[Series 3700 R12.2]
00
31
LAN Interface
number
0
1
Available
Not available
NOTE 1: To provide Tone Disabler, firmware version of SC-3591 IPS IPTT PROG-B1 or later of SIP card is
required.
NOTE 2: Tone Disabler is a feature to improve FAX communication rate.
When detecting V.25 tone (2100 Hz) with phase inversion, Echo Canceller/NLP (Non Linear Proces-
sor) is set to OFF. When detecting V.25 tone (2100 Hz) without phase inversion, Echo Canceller/NLP
(Non Linear Processor) is set as same as voice setting.
79 SIP trunk source IP address
check
[Series 3800]
00
31
LAN Interface
number
0
1
To provide
Not provided
NOTE: This feature is ineffective when CMA7 Y=46 is set to 0 (Point-to-Multipoint connection).
Continued on next page
~ ~ ~ ~ ~
NOVEMBER/15/2006
CM0A

Table of Contents

Other manuals for NEC UNIVERGE NEAX 2000 IPS

Related product manuals