– 159 – NWA-008844-001 Rev.5.0
91ch3001.fm
COMMAND CODE
TITLE:
LAN DATA ASSIGNMENT
0B
NOTE 1: To provide the VLAN function to the system, clear the IP Address and Subnet Mask for the
system that has been set by CM0B Y=00>00 and 01 after setting the data by CM0B Y=02>03
and 04.
NOTE 2: This data is only available to PZ-M606-A (ETHER) card.
NOTE 3: This data is available when location number is not assigned by CM12 Y=39, 50.
NOTE 4: For the visitor station in the visitor site, the tenant number set by this data is effective, even if
the tenant number has been set by CM12 Y=04.
NOTE 5: This data must be set to the MP cards of each Remote Site.
NOTE 6: Since this data is written to the Flash Rom of MP card directly, the data cannot be saved/load-
ed/verified. But the data can be cleared by the system data memory all clear.
Continued on next page
INITIAL
JUNE/01/2007
CM0B
To Next Page
Loading...
