– 346 – NWA-008844-001 Rev.5.0
91ch3003.fm
COMMAND CODE
TITLE:
TRUNK ROUTE DATA
35
(3) When assigning a Tie line, the data in CM35 Y=09 (Incoming connection signalling) should be
similar to that of CM35 Y=20 (Sender starting condition).
The table below shows the assignment of the sender starting condition in relation to the incoming
connection signalling.
NOTE: ( ) indicates the data to be assigned.
(4) Table below shows the value of C.O, LD and DID trunk Gain PAD assigned by CM35 Y=47,
Data=0-3 (T: Transmitter PAD (dB), R: Receiver PAD (dB)).
(5) After setting CM35 Y=100, system reset is required.
After setting CM35 Y=113, DCH card reset is required.
After setting CM35 Y=142, DBM card reset is required.
ASSIGNMENT PROCEDURE:
INCOMING CONNECTION
SIGNALING (CM35 Y=09)
SENDER START CONDITION
(CM35 Y=20)
REMARKS
Ground Start (01) Ground Start (02)
Loop Start (15) Loop Start (15)
Wink Start (03) Wink Start (00)
Delay Dial (04) Delay Dial (01)
Immediate (05) Timing Start (15)
2nd DT/Timing (06) Timing Start (15)
CM35 Y=47 DATA COT (T/R) LDT/DID (T/R) REMARKS
0 +1.5/6.5 +1.5/6.5
1None0/0
2 None +0.5/+2.5
3 +0.5/+5.5 +0.5/+5.5
+ 35YY/YYY + +
TRUNK
++ +
ROUTE
DATA
(2 digits)
EXE
ST
DEDE
(1-4 digits)
CM35
To Next Page
Loading...
