– 359 – NWA-008844-001 Rev.5.0
91ch3003.fm
COMMAND CODE
TITLE:
TRUNK ROUTE DATA
35
: Initial Data
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
78 Number of digits to be
converted on DID for Devel-
opment Table 0
0
1
Leading 2-4 digits
All digits of DID number are converted by
CM76
CM35
Y=12, 18
CM76
79 Terminal connection form
for ISDN Basic Rate
Interface
0
1
Point-to-Point
Point-to-Multipoint
NOTE: Set 0 for 4BRT card.
83 Trunk seizure sequence for
an outgoing call
0
1
As per CM08>078
By allotter
CM08>078
CMA7 Y=64
86 Centrex trunk 0
1
To provide
Not provided
87 Distinctive Ringing by
detecting the ringing signal
from main PBX or Centrex
0
1
To provide
Not provided
NOTE 1: When this function is utilized, be sure
to set Trunk Line Appearance as the
terminating method. Set CM30
Y=02, 03 to 02.
NOTE 2: Tone Ringer is selected by CM35
Y=34, lamp control is set by CM35
Y=32 respectively.
CM30
Y=02, 03
CM30 Y=18
89 Cyclic Redundancy check-
ing for DTI trunk
0
1
To provide
Not provided
90 Special facilities 0
2
3
5
6
7
No. 7 CCIS, IP trunk, SIP trunk
ISDN-Basic Rate Interface
ISDN-Primary Rate Interface
Q-SIG (ETS300 172)
PBX-PBX Interface for Roaming
(Q931a digital) [For PCS]
Not used
CM30 Y=35
91 Common Channel Handler
(CCH) number used for No.
7 CCIS/IPT/SIP
0
7
NONE
CCH0
CCH7
No data
CM06 Y=07
CM30 Y=35
CMA7
CMA8
Continued on next page
BRT INITIAL
INITIAL
INITIAL
~
~
DECEMBER/02/2005
CM35
To Next Page
Loading...
