– 532 – NWA-008844-001 Rev.5.0
91ch3005.fm
COMMAND CODE
TITLE:
DIGIT CONVERSION ON DID CALL
76
NOTE 1: When digit conversion of the leading 2-4 digits of a DID incoming LDN is available (CM35
Y=78, Data=0), the leading 2-4 digits of the LDN should be assigned as the first data. (When
the DID incoming LDN is one digit, the digit conversion for only one digit is not available.)
NOTE 2: If CM35 Y=143 is set to “1” for Event Based CCIS, this command must be set.
Continued on next page
: Initial Data
Y
1ST DATA
2ND DATA
REMARKS
No. MEANING DATA MEANING
01
02
03
04
For Day Mode
For Night Mode
For Mode A
For Mode B
000-999:
Number Conver-
sion Block No.
assigned by
CM76 Y=00/90,
CM2A Y=50-52
X
XXXXXXXX
Station number to be terminated
NOTE 1
CM10/CM14
CM11
CM1A
DXX
D02
D03
D04
D09
D10
D11
D12
D13
D14
D16
Change terminating system to:
Trunk Line (Direct) Appearance
Trunk Line (Direct) Appearance +
TAS
Direct-In Termination
Automated Attendant
Attendant Console + TAS
Attendant Console + Trunk Line
(Direct) Appearance
Attendant Console + Trunk Line
Appearance + TAS
TAS
Attendant Console
Remote Access to System (DISA)
CM35 Y=18,
78
CM30 Y=02,
03, 40, 41
CM30 Y=18
CM30 Y=04,
05, 42, 43
CM49 CM64
BBBBBXXX Mate-Side Trunk No. of Virtual
Trunk
XXX: 000-255
NOTE 2
NONE No data
~
JANUARY/20/2006
CM76
To Next Page
Loading...
