– 783 – NWA-008844-001 Rev.5.0
91ch3008.fm
COMMAND CODE
TITLE:
D
term
IP APPARATUS INFORMATION
FA
NOTE: If you want to interrupt updating or to reset count data, do the following operation.
When this operation is performed, the count data which can be read by CMFA Y=50>01/02
is cleared.
Y 1ST DATA INDICATION
No. MEANING DATA MEANING DATA MEANING
20 • By sending ICMP TYPE=8 (ping request) to the destination terminal, you ask whether the terminal is correctly
connected/set or not.
• Receiving ICMP TYPE=0 (ping reply) from the destination terminal means that the terminal is correctly con-
nected/set.
• Receiving ICMP TYPE=3/11/12 (reply [error]) from the destination terminal means that the terminal is not
correctly connected/set.
NOTE 1: If ICMP TYPE not listed above is received, “HARDWARE ERROR” is displayed.
NOTE 2: TOS (Type of Service) is present in IP header, and represents QoS (Quality of Service).
Precedence/delay/throughput/reliability that determine quality are contained within TOS.
30 Read the D
term
IP
Station number reg-
istered in Fixed
Connection Mode
[Series 3700
R12.2]
000
255
Block No. X
XXXXXXXX
CCC
NONE
D
term
IP Station No.
Clear
No data
NOTE 1: The station number for Fixed Connection Mode registered by CM12 Y=92 is read by this command.
NOTE 2: When the 2nd data is set to “CCC”, the MAC Address of the appropriate D
term
IP registered by CM12
Y=92 is cleared.
50 Read the D
term
IP
firmware’s status of
automatic update
[Series 3200 R6.1
(R6.1)]
00 Status of auto-
matic update
NOTE
00
01
10
Not started
Now updating
Completed
01 Number of termi-
nal that succeeded
in updating
XXX Number of succeeded terminal
02 Number of termi-
nal that failed in
updating
XXX Number of failed terminal
~
~
ST + +
FA50
DE+ DE
00 CCC
EXE
+++
JULY/01/2006
CMFA
To Next Page
Loading...
