– 866 – NWA-008844-001 Rev.5.0
91ch3009.fm
COMMAND CODE
TITLE:
SMDR/MCI/PRINTER FOR PMS FUNCTIONS
DD01
: Initial Data
1ST DATA
2ND DATA
DATA FUNCTION
13 Room Status Code set by Check Out operation
[Series 3900]
0: Not used
1:
8:
14 Room Status Code when pressing Call Recording Function
Button
[Series 3900]
0: Not used
1:
8:
15 Call charge printout when Room Status Code matches the Room
Status Code for Check Out set by DD01>13
[Series 3900]
0 : Not available
1 : Interim Printout per station
2 : Audit Printout per station
100
101
102
103
AP00 RS port assignment for SMDR/MCI/printer for PMS
Port 0
Port 1
Port 2
Port 3
0: No data
3 : SMDR with NEAX 2400 IMS
Format
10 : MCI
12 : External printer for PMS
NOTE 1: When CMDD01>100-103: 3/10 is assigned, the initial data is set to specified port as the interface
condition. For interface conditions, refer to CMDD10 PRECAUTION. See CMDD10
NOTE 2: When using the RS port for SMDR, two ports of port 0 to 3 can be assigned.
When two ports are assigned for SMDR, any one of two port should be assigned to SMDR termi-
nal 1 by CMDD10>X00.
NOTE 3: When using the RS port for MCI, one port of port 0 to 3 can be assigned.
NOTE 4: When using the RS port for PMS, port 1and port 3 are available.
NOTE 5: When setting the second data to 12, the initial data of CMDD10>X00, X01, X02, X03, X04, X05
is set automatically.
Continued on next page
Room Status Code
~
Room Status Code
~
AP00 INITIAL
JUNE/01/2007
CMDD01
To Next Page
Loading...
