Oce TDS700 - Page 221

221
Scanning originals with filing strip
Illustration
[140]
[140] Example of adjusting the leading or trailing strip of an original
Copy with removed filing strips along the leading and trailing strip
1. Open the ‘Sheet’ card in the ‘Original’ section.
2. Press the ‘Remove strip’ function key.
[141]
[141] Removing strip
3. Adjust the values in mm for the trailing strip using the numeric or arrow keys.
4. Press the ‘Remove strip’ function key again.
5. Adjust the values in mm for the leading strip using the numeric or arrow keys.
6. Make other settings as required.
7. Feed the original.
Copy with added filing strips along the leading and trailing strip
1. Open the ‘Layout’ card in the ‘Copy’ section.
2. Press the function key ‘Add strip’ function key.
[142]
[142] Adding strip
3.
Adjust the values in mm for the trailing strip using the numeric or arrow keys.
4. Press the function key ‘Add strip’ again.
5. Adjust the values in mm for the leading strip using the numeric or arrow keys.
6. Make other settings as required.
7. Feed the original.