DMTA-10084-01EN, Rev. 2, November 2018
Chapter 9
106
1. In the Create setup page, press the Enter key to select the file type value, and then
turn the adjustment knob to choose INC or CAL.
2. Press the Tab key to highlight the Filename box.
3. Enter characters (up to 32) using the virtual keypad, adjustment knob, and Enter
key (see Figure 9-3 on page 106).
Figure 9-3 File name edit
Special characters such as spaces, decimals, slashes, and punctuation are not
permitted in the Filename box.
4. For each of the next three optional boxes (Description, Inspector ID, Location
Note) press the Tab key, and then repeat step 3 to enter information.
5. If the File Type is INC:
a) Press the Tab key, and then enter an optional ID Prefix.
This prefix will save as part of the ID but will not increment.
To Next Page
Loading...
