Olympus EPOCH 6LT - Figure 9-8 Viewing All the Ids in a File

DMTA-10084-01EN, Rev. 2, November 2018
Chapter 9 112
To choose from a large number of IDs
Calibration (CAL) files only contain a single ID.
1. While on the setup parameters page (see Figure 9-7 on page 111), press the Tab
key to highlight the Select ID button, and then press the Enter key to open the
Select ID setup page (see Figure 9-8 on page 112).
2. Turn the adjustment knob to choose an ID.
3. Press the Tab key to select the ID and highlight the Select button.
4. Press the Enter key to view the data for the selected ID.
Figure 9-8 Viewing all the IDs in a file
9.4.2.3 Taking a Snap Shot of the Waveform
You can take a snap shot (screen shot) of the waveform data screen.
NOTE