DMTA-10084-01EN, Rev. 2, November 2018
Chapter 9
122
To select an ID within a file
1. In the Manage page, turn the adjustment knob to highlight a file.
2. Press the Tab key to highlight the Select ID button, and then press the Enter key
to select the highlighted file and open the Select ID setup page.
3. Turn the adjustment knob to scroll through the saved IDs in the file, and then
press the Tab key to select an ID and select the Select button (see Figure 9-8 on
page 112).
4. Press the Enter key to confirm your ID selection.
Figure 9-18 Select ID setup page
9.4.4 Memo
The Memo setup page enables you to enter descriptive comments to include with
stored data. Memos can be used to provide further details about a measurement
condition or calibration. Memos can only be entered into the currently open file (see
“Selecting a File as the Active Storage Location” on page 108). To add a memo to a
To Next Page
Loading...
