DMTA-10084-01EN, Rev. 2, November 2018
Pulser/Receiver Adjustments
59
6. Pulser/Receiver Adjustments
This chapter describes how to adjust the EPOCH 6LT pulser/receiver.
6.1 Adjusting the Gain (System Sensitivity)
To adjust the gain
1. On the live A-scan screen, press the Tab key to select the Gain adjustment box
(see Figure 6-1 on page 59).
2. Turn the adjustment knob to set the gain (system sensitivity).
The total gain (system sensitivity) is 110 dB.
Figure 6-1 Highlighted Gain adjustment box
To Next Page
Loading...
