DMTA-10084-01EN, Rev. 2, November 2018
Chapter 9
138
— To finish recording and save the video to a file, select Save (see “To save a
recording” on page 138 for details).
— To erase the current video, select Clear.
4. To flag (or mark) a point in the video, select the Flag button, and then press the
Enter key.
When reviewing the video, you can quickly jump from flag to flag.
To save a recording
1. Select Save to finish recording and display the Create (video file) setup page.
2. Press the Enter key to enter a Filename.
3. Enter characters (up to 32) using the virtual keypad, adjustment knob, and the
Enter key (see Figure 9-30 on page 138).
Figure 9-30 Create video file setup page
4. For each of the next three optional boxes (Description, Inspector ID, Location
Note) press the Tab key, and then repeat step 3 to enter information.
To Next Page
Loading...
