Oracle X7-2 - Page 160

Install the Front Indicator Module
3.
If not installed, install the FIM cable through the plastic temperature sensor
housing [1].
4.
Connect the FIM cable to the replacement FIM assembly [1, 2].
5.
Using a Phillips screwdriver, tighten the two screws to secure the temperature
sensor housing to the FIM assembly [2].
6.
Carefully insert the FIM assembly into the front panel of the server chassis [3].
7.
Install and tighten the two Phillips screws to secure the FIM assembly to the
server chassis [3].
8.
Return the server to operation.
a.
Return the server to the normal rack position.
See “Return the Server to the Normal Rack Position” on page 212.
160 Oracle Server X7-2 Service Manual • October 2017