Automatic Operation (Position Control)
8-60
Offset
Name Description
00CH Dwell time
After the completion of the positioning operation of this table;
when the mode is C: Continuance point, the motor stops for the dwell time and
the next operation is started.
When the mode is P: Pass point, it is ignored.
When the mode is E: End point, the positioning done contact turns on after
waiting for the dwell time.
15-0 Dwell time 0
Range: 0 to 32,767 (ms)
Any other settings will be errors.
00DH
Auxiliary output
code
Sets the data to be output to the auxiliary output code in each axis information &
monitor area by the setting of the auxiliary output mode in the parameter setting
area.
15-0 Auxiliary output code 0 Set an arbitrary value.
00EH
-01FH
Reserved for
system
－
To Next Page
Loading...
