Settings of FP7 MC Unit
Using CMI Tool
5-2
5.1 FP7 MC Unit Common Settings
5.1.1 FP7 MC Unit Common Settings Dialog Box
In the "MC common settings" dialog box, The EtherCAT communication cycle and the
operations when errors occur are set. The following procedure is explained on the condition
that CMI has already started.
1. Select "Parameter" > "MC common settings" from the menu bar.
The "MC common settings" dialog box is displayed.
2. Set necessary parameters in accordance with the intended use.
• Although the data being edited is held until finishing CMI even when the
dialog box is closed with the X mark during the editing, save parameters by
executing "File" > "Save As" as necessary.
To Next Page
Loading...
