Basic Procedure
4-6
4.3 Setting of Used Axes
4.3.1 Registration of Used Axes
Axes to be used in FP7 MC Unit are allocated by CMI. The following procedure is explained
on the condition that FP7 MC Unit has been already allocated in the I/O map.
1. Select "Tools" > "Control Motion Integrator" from the menu bar of FPWIN
GR7.
The "Select Slot no." dialog box is displayed.
2. Select the slot number and unit of the FP7 MC Unit that the setting is made,
and press the [OK] button.
"CMI" is activated, and the start dialog box is displayed.
To Next Page
Loading...
