Settings of FP7 MC Unit
Using CMI Tool
5-16
5.3.2 Operation Patterns and Tables
• Use a number of tables if the positioning patterns consist of P-point control (pass point
control), C-point control (continuance point control), and J-point control (speed point control).
• In these types of control, the tables are created continuously on CMI, and "E-point control" is
selected for the operation pattern for the last table.
• Start requests are made by specifying the starting data table numbers for each control in
user programs.
Example) When performing three-speed positioning control by P-point control (pass
point control)
Create three positioning tables, and select "E: End point" for the last table. Also, start requests
are made by specifying the starting table numbers in user programs.
• For details of each control, refer to "8 Automatic Operation (Position
Control)".
To Next Page
Loading...
