9.4 Electronic Gear Function
9-15
9.4.2 Types and Contents of Setting Parameters
For using the electronic gear, set the following parameters in the "Synchronous parameter
settings" menu.
Electronic gear
setting - Use
Not use
Select the operation of the electronic gear function.
Use / Not use
The gear ratio of the electronic gear is set to 1:1 if the electronic gear is
not used, and the operation of the master axis is input as it is into the
electronic clutch.
Gear ratio numerator 1
Determines the gear ratio of the electronic gear.
Electronic gear ratio is determined by the following formula.
Output speed of electronic gear = Operating speed of master axis x
(Gear ratio numerator/Gear ratio denominator)
Setting range: U1 to U2147483647
Gear ratio
denominator
1
Gear ratio change
time
1
The time required to change the current gear ratio to a new gear ratio if
the new gear ratio is set for the electronic gear in operation.
Setting range: U1 to U10000 (ms)
• The gear ratio of the electronic gear is set to 1:1 when selecting "Not use"
for the electronic gear, and the operation of the master axis is input as it is
into the electronic clutch.
To Next Page
Loading...
