Panasonic AFP7MC16EC - Synchronous Parameter Setting Errors (from 00 F0 5000 H)

Troubleshooting
15-22
15.3.6 Synchronous Parameter Setting Errors (From 00F0 5000H)
 Synchronous parameter: Common errors
●: Recoverable, -: Unrecoverable
Error
code
Error name Description Object Recovered Countermeasures
5000H
Synchronous master
setting value error
The setting for the synchronous
master axis is incorrect.
- Setting error (Value is
incorrect.)
- Own axis setting
Each
axis

Check the set value.
If the error occurs repeatedly
with the correct set values,
please contact us.
5002H
Synchronous setting
disable error
The synchronous setting
request was made in the
following axis setting.
- Its own axis (slave axis) is set
as the master of another axis.
- The master axis is set as the
slave axis of another axis.
- Its own axis (slave axis)
belongs to the interpolation
group.
Each
axis

5006H
Synchronous slave
single deceleration
stop deceleration
time
The setting for the synchronous
slave single deceleration stop
time is incorrect.
Each
axis

(Note): To simplify the displays, only the lower four digits (Hex) of each error code are displayed in the above table.
 Synchronous parameter: Electronic gear related errors
●: Recoverable, -: Unrecoverable
Error
code
Error name Description Object Recovered Countermeasures
5100H
Electronic gear -
Gear ratio
numerator setting
error
The setting for the gear ratio
numerator of the electronic gear
is incorrect.
Each
axis

Check the set value.
If the error occurs repeatedly
with the correct set values,
please contact us.
5101H
Electronic gear -
Gear ratio
denominator setting
error
The setting for the gear ratio
denominator of the electronic
gear is incorrect.
Each
axis

5102H
Electronic gear-
Gear ratio change
time setting error
The setting for the gear ratio
change time of the electronic
gear is incorrect.
Each
axis

(Note): To simplify the displays, only the lower four digits (Hex) of each error code are displayed in the above table.