Panasonic AFP7MC16EC

16.5 Unit Memories (Common Area)
16-47
16.5.12 Synchronous Control Monitor Area
●: Available, -: Not available
Axis no.
Unit
memory
no. (Hex)
Name Default Description R W
1 UM 02390
Synchronous
master axis
information
monitor
HFFFF
Stores the information on the master axis of
synchronous control.
Value
Master axis
Under
synchrono
us control
Synchrono
us control
canceled
H FFFF H FFFF
No synchronous
setting
H 0000 H 8000
The target axis for
monitoring is the
master axis.
(For FP7 MC Unit,
the value for the
master axis does
not change even
when the
synchronous
control is
canceled.)
H 0001
H 8001
Axis 1
H 0002 H 8002 Axis 2
： ： ：
H 0010
H 8010
Axis 16
： ： ：
H 0020 H 8020 Axis 32
： ： ：
H 0040
H 8040
Axis 64
H 0041 H 8041 Virtual axis 1
： ： ：
H 0060 H 8060 Virtual axis 32
 -
1 UM 02391
Synchronous
output
function
selected state
monitor
H0
Stores the information on the master axis of
synchronous control.
bit.
Name
Value
0
Electronic gear
operation settings
0: Not use
1: Use
1
Clutch operation
setting
2
Electronic cam
operation setting
3
Advance angle
correction
operation setting
15-4
- -

-
1
UM 02392
-UM 02395
Reserved for
system
- - - -
(2-64
Virtual 1-32)
UM 02396
-UM 025CF
As well as the area for axis 1, 6-word area is allocated to each axis in the
following configuration.
 Synchronous master axis information monitor area: 1 word
 Synchronous output function selected state monitor area: 1 word
 Reserved area for the system: 4 words

-
-
UM 025D0
-UM 0260F
Reserved for
system
- - - -