13.12 Connection with Slave Encoder Input Device
13-43
13.12.2 Configuration
For connecting an encoder input device to the network, it should be allocated to use axes in
CMI.
1. Register the number of counters of the encoder input device in the axis
change setting.
After that, press the [Encoder axis settings] button and set the registered axes are
encoder axes.
* (asterisk) is displayed for the axes set as encoder axes.
2. Register the encoder input device as a slave. (Refer to 4.4 Setting of
Network Configuration.)
Allocate the counters of a
slave device to used
Set the slave device
allocated to the axes as
an encoder.
Allocate axes for the
number of counters of the
slave device.
To Next Page
Loading...
