Panasonic AFP7MC16EC

9.1 Synchronous Control
9-3
 Execution order of synchronous control and setting procedures
The following section provides information on the outline of functions achieved by
synchronous control and setting procedures for the functions.
M
as
t
er
a
xi
s op
eration
Master axis
settings
S
l
av
e
ax
isou
tput
Electronic gear
settings
Phase clutch OFF
Electronic clutch
settings
Advance angle
correction
Electronic cam
settings
M
ak
e master axis settings for each operating axis.
Each operating axis will work as a slave axis if master axis settings
are made for the operating axis.
Select the use or non-use of the electronic gear. Various electronic
gear settings are required if the electronic gear is used.
Select the use or non-use of the electronic clutch. Various
electronic cutch settings are required if the electronic gear is used.
Select the use or non-use of t
he electronic cam. Various electronic
cam settings are required if the electronic gear is used.
In addition, electronic cam pattern settings are required in the case
of using the electronic cam.