Automatic Operation (Synchronous Control)
9-28
Cam pattern specifications
Resolution 1024, 2048, 4096, 8192, 16384, 32768
No. of cam patterns
AFP7MC16EC AFP7MC32EC AFP7MC64EC
Resolutions of 1024,
2048, 4096, and
8192:
64 128 256
Resolution of 16384: 32 64 128
Resolution of 32768: 16 32 64
Section setting 100 %/cycle, 20 sections max.
Displacement setting 100 % setting
Cam curve
Constant speed / Constant acceleration / Simple harmonic / Cycloid /Modified
trapezoid / Modified sine / Modified constant speed / Asymmetric cycloid / Asymmetric
modified trapezoid / Trapecloid / One-dwell cycloid, m=1 / One-dwell cycloid, m=2/3 /
One-dwell modified trapezoid, m=1 / One dwell modified trapezoid, Ferguson / One-
dwell modified trapezoid, m=2/3 / One-dwell modified sine / One-dwell trapecloid / No-
dwell modified trapezoid / No-dwell constant speed / NC2 curve
Adjustment function
Function to adjust the displacement of desired point data: Max. 1,000 points (in units of
cam data)
Shift function Phase shift in created cam data: 0 to 100%
Display
Displacement / Speed / Acceleration / Jerk
The display can be changed arbitrarily by the check box of CMI.
• The advance angle correction function has been added, which corrects the
response delay of cam output axis. This function is available since FP7 MC
Unit Ver. 1.20. For details, refer to "9.5.5 Phase Specification Clutch OFF
Function".
To Next Page
Loading...
