Automatic Operation (Synchronous Control)
9-36
Shift of cam table
Although created cam patterns are defined for the phases of 0 to 100%, phases used as a
reference for created cam patterns may be different in actual operations. The shift of cam
table is a function to set the phase of the position of current value coordinate system 0 to be a
percentage of a created cam pattern.
Image of shifting electronic cam
0 1000-100 0
0 100 0-100 0
８１９/１０２４
0
100 0-100 0
Cam pattern
example
• Cycle: 1000
• Resolution:
1024
Current
coordinate position
after the clutch.
• In the case of setting coordinate 0 to 0% phase (0/1024).
Current
coordinate
system after
the clutch.
Current
coordinate
system after
the clutch.
• In the case of setting coordinate 0 to 80% phase (819/1024).
To what value
the phase of
coordinate 0 is
set?
Select Shift from "Section", and set a shift amount.
The created cam pattern is shifted by 10% and the display is updated.
Before change
After change
Storage of cam table
The created cam table is stored as a file together with other parameter data set by CMI.
To Next Page
Loading...
