Panasonic AFP7MC16EC

3.1 Setting of Node Address (ID)
3-3
 Parameter settings by Panaterm
The Station Alias (ID) is set by setting the parameters of Servo Amplifier [MINAS A6B/A5B].
Parameter
Parameter
name
Function
Classification Number
07 040
Station alias
setting (upper)
The high-order 8 bits of station alias are set.
Station alias Higher 8 bits
Lower 8 bits
Rotary switch
setting
=
+
Setting of
Pr7.40
However, Pr7.40 must be always set to "0". Because the
maximum number of slaves for FP7 MC Unit is 192, the
high-order 8 bits are "0".
07 041
Station alias
selection
The setting method of station alias is specified.
Setting Function
0
The value set by the rotary switches on the
front panel and Pr7.40 is used as the
station alias.
1
The set value in the ESC configuration area
(SII area) is used the station alias.
 Rotary switch setting
When the set value for Pr7.41 is "0", it is set using the two rotary switches on the front panel
of Servo Amplifier MINAS A6B/A5B. When using the software CMI, set it to "00".
Setting
value
Front panel
display
Function
MSD LSD
0 0 0
The settings on the FP7 MC Unit side that is the higher master are valid.
Make the setting using the setting software CMI.
01 to C0
(1 to 192)
Other numbers
The node address (ID) set by the rotary switches is valid. It is set by
combination of hexadecimal 2 digits.
Example) When node address is "20", set MSD to 1 and LSD to 4.
KEY POINTS
• Node addresses (IDs) can be set regardless of the connection order.
• When the same unit number is redundantly specified on the same network,
an error occurs.