16.8 Unit Memories (Synchronous Control Setting Area)
16-81
●: Available, -: Not available
Axis no.
Unit
memory
no. (Hex)
Name Default
Description R W
1 UM 63F9A
Advance
angle
correction
parameter
change time
U100
Set the time required until a changed value is
reflected when the parameter related to advance
angle correction (advance angle correction
reference speed or advance angle correction
reference amount) is changed during the electronic
cam operation.
Range: 0 to 10,000 (ms)
Any other settings will be errors.
1
UM 63F9B
-UM 63FAF
Reserved for
system
- - - -
(Note): The above table shows the unit memory numbers of axis number 1. For details of the whole configuration,
refer to "16.8.1 Configuration of Synchronous Control Setting Area".
To Next Page
Loading...
