Basic Procedure
4-8
5. Drag the line to be allocated for interpolation to the interpolation group field.
The following picture shows the allocations of "axes 1 and 2" to "group 1" and
"axes 3 and 4" to "group 2" of interpolation groups. When removing the axes from
the interpolation groups, right-click on the target axis in the "Interpolation group"
field and execute "Clear".
6. Press the [OK] button.
A confirmation message is displayed.
7. Confirm the change and press the [Yes] button.
The data table is created in accordance with the setting content. The
corresponding axis numbers are also displayed in the project tree.
To Next Page
Loading...
