Automation : Automation Modes
14 - 402
This contextual menu also enables the automation mode for the whole strip, one or more buses or the entire
mixer to be set by choosing Strip, Bus or Mixer.
Selecting one of these opens a sub-menu. Selecting Automation opens a further sub-menu offering the choice of
automation modes:
WARNING: We advise that users do not automate Buses or Aux Send ON/OFF as this could cause
Delay Compensation issues. As an alternative simply automate Bus or Aux Send Gain.
VS3 Effects
Right-clicking over a VS3 Effect in a Strip, pops up a contextual menu. Selecting VS3 > Automation opens a sub-
menu offering a choice of seven automation modes:
Strip > Automation sub-menu
VS3 Effects > Automation sub-menu
To Next Page
Loading...