Automation : Automation Modes
14 - 403
Follow Strip mode No mode identification letters shown in effect block. Effect Automation follows the mode
set for the entire Strip
Tou ch T shown in the effect block.The automation starts writing a new pass when the control is
touched and stops writing when the control is released. Behavior on release depends on
the release mode for the Strip.
Latch L shown in the effect block. The automation starts writing a new pass when the control is
touched. The value when the control is released will continue to be written until the
transport stops.
Trim Touch TT shown in the effect block. The automation starts updating the current pass when the
control is touched and stops updating when the control is released.
Trim Latch TL shown in the effect block.The automation starts updating when the control is touched
but continues when the control is released and stops only when the transport stops.
Record Effect block shaded red. With the transport in Play, and the Master Automation Controls
in Write mode, the current state of all controls is recorded as automation data.
Read Effect block shaded green.The control(s) follow the last automation data recorded for
them or maintain their default position where no previously recorded automation data
exists.
Isolate No mode identification letters shown in effect block. The control(s) are isolated from any
automation moves already recorded. Controls can be moved without affecting existing
automation data.
VS3 Effects Automation modes
To Next Page
Loading...