Settings : Remote Control
29 - 762
Send In/Out Preset options
By default, Pyramix sends Edit Video In/Out and Edit Audio In/Out points when an In/Out point is set in the Trans-
port Control panel. These options enable these commands to filtered out if necessary.
• Filter In/Out Preset (video)
• Filter Audio In/Out Preset
Status Bit Filtering Options
Some SonyP2 devices do not report the Standby bit correctly (always in Standby). In this case the Pyramix Trans-
port Window reports Standby status continuously, thereby hiding the true status. You may wish to set filter if the
target machine fails to report standby correctly.
• Filter the Standby bit
Edit Preset channel options
Edit Preset in the 9-pin P2 protocol world means Track Arming.
These options enable Track Arming commands to be filtered out if required.
• Send Analog Edit Preset (A1..A2)
• Send Digital Edit Preset (D1..D8)
This feature is mostly relevant where a console or a third-party record/monitoring controller is used for record
commands.
Edit Preset Record Options
These 3 options Inhibit Recording when one of the Video/Timecode/Assemble Edit preset modes is checked and
the corresponding Track is armed. In a typical TV workflow, when audio is laid back to the tape, it is essential to
prevent the video track entering record (edit) These options avoid nasty accidents.
• Inhibit Video Record
• Inhibit TimeCode Record
• Inhibit Assemble Record
This feature is mostly relevant where a console or a third-party record/monitoring controller is used for record
commands.
To Next Page
Loading...