Quantum Scalar i6000 - Requirements for Automated Media Pool; Configure Automated Media Pool; Create an AMP Partition

Scalar i2000 Installation Guide 263
14 Repeat Step 10 on page 261 through Step 13 on page 262 for each drive that will be installed.
15 Gather the Fibre optical cables and put them inside the Velcro straps that are mounted on the right side
of the module.
16 Detach the ESD strap and close the door.
Note
The FC port and drive numbers will change according to Table 5 on page
114.
use Velcro straps
to secure cables