SERVICE PROGRAM MODE
SM 5-21 C262/C265
Service
Tables
Notes
1: 2-1-1 (Default print speed, cpm)
1: 60, 2: 75, 3: 90, 4: 105, 5: 120, 6: 135
2: 2-4-1 (Machine Code Setting)
By entering the machine code (e.g. for C262-52, input 262-52), the following values
go to the factory settings for that model:
• Machine destination (SP2-4-4)
• Display language
• Drum Selection (SP2-4-3)
• Vendor selection (SP2-4-5)
NOTE: 262-17: Ricoh North America
262-27: Ricoh Europe
* Use the point ( . ) key to enter ‘-.’
3: 2-4-3 (Drum Selection – A3 or DLT)
To detect the size of the drum, the machine refers to the dip switch settings on the
drum. But A3 and DLT have the same dip switch configuration. Then the machine
uses this SP to tell the difference between A3 and DLT.
The drum size detected by the machine changes the master making area. It also
affects the available range for the default image position shift (top/bottom, SP2-1-2).
NOTE: There is no A4 setting for this SP, because the machine automatically
detects an A4 drum by the dipswitch setting, and adjusts the master
making area and image shift accordingly.
Drum Selection Range that can be set (SP2-1-2)
DLT Drum -10 mm to + 10 mm (0.25mm)
A3 Drum -15 mm to + 15 mm (0.25mm)
A4 Drum -15 mm to + 15 mm (0.25mm)
CAUTION: For the DLT drum, the display shows -15 mm to + 15 mm. But you
must enter a value in the range of -10 mm to + 10 mm.
To Next Page
Loading...
