Rockwell Automation PowerFlex 7000 Technical Data

Parameter Descriptions 2-63
7000-TD002A-EN-P – September 2007
Speed Profile Parameters
Acceleration Time 1 [Accel Time 1]
Linear Number: 65
Default Value: 5.0 sec
Minimum Value: 0.0 sec
Maximum Value: 1200.0 sec
Access Level: Advanced
Read/Write: Read/Write
This parameter specifies the time for the speed reference to increase from zero to Ramp Speed 1. In
conjunction with Ramp Speed 1 (73), it is used to determine the rate at which drive will ramp the output
stator frequency during flying starts. For details refer to section of flying re-start in Chapter 1 – Functional
Description.
Acceleration Time 2 [Accel Time 2]
Linear Number: 66
Default Value: 3.0 sec
Minimum Value: 0.0 sec
Maximum Value: 1200.0 sec
Access Level: Advanced
Read/Write: Read/Write
This parameter specifies the time for the speed reference to increase from Ramp Speed 1 to Ramp
Speed 2.
Acceleration Time 3 [Accel Time 3]
Linear Number: 67
Default Value: 14.0 sec
Minimum Value: 0.0 sec
Maximum Value: 1200.0 sec
Access Level: Advanced
Read/Write: Read/Write
This parameter specifies the time for the speed reference to increase from Ramp Speed 2 to Ramp
Speed 3.
Acceleration Time 4 [Accel Time 4]
Linear Number: 68
Default Value: 10.0 sec
Minimum Value: 0.0 sec
Maximum Value: 1200.0 sec
Access Level: Advanced
Read/Write: Read/Write
This parameter specifies the time for the speed reference to increase from Ramp Speed 3 to Ramp
Speed 4.

Rockwell Automation PowerFlex 7000 Specifications

General

Brand	Rockwell Automation
Model	PowerFlex 7000
Category	DC Drives
Language	English