Rockwell Automation PowerFlex 7000 Technical Data

Parameter Descriptions 2-149
7000-TD002A-EN-P – September 2007
Analog Rectifier Test Point 4 [Anlg RecTstPt4]
Linear Number: 125
Default Value: 700
Minimum Value: 0
Maximum Value: 779
Access Level: Service
Read/Write: Read/Write
This parameter specifies the linear number of the parameter associated with analog test point 4
(DAC_TP4) on the rectifier side Drive Processor Module (DPM). This is a non-isolated 0-10 V output.
Analog Inverter Test Point 1 [Anlg InvTstPt1]
Linear Number: 511
Default Value: 490
Minimum Value: 0
Maximum Value: 779
Access Level: Service
Read/Write: Read/Write
This parameter specifies the linear number of the parameter associated with analog test point ITP1 on
the Drive Processor Module (DPM). This is a non-isolated 0-10 V output.
Analog Inverter Test Point 2 [Anlg InvTstPt2]
Linear Number: 512
Default Value: 289
Minimum Value: 0
Maximum Value: 779
Access Level: Service
Read/Write: Read/Write
This parameter specifies the linear number of the parameter associated with analog test point ITP2 on
the Drive Processor Module (DPM). This is a non-isolated 0-10 V output.
Analog Inverter Test Point 3 [Anlg InvTstPt3]
Linear Number: 126
Default Value: 291
Minimum Value: 0
Maximum Value: 779
Access Level: Service
Read/Write: Read/Write
This parameter specifies the linear number of the parameter associated with analog test point 3
(DAC_TP3) on the inverter side Drive Processor Module (DPM). This is a non-isolated 0-10 V output.
Analog Inverter Test Point 4 [Anlg InvTstPt4]
Linear Number: 127
Default Value: 306
Minimum Value: 0
Maximum Value: 779
Access Level: Service
Read/Write: Read/Write
This parameter specifies the linear number of the parameter associated with analog test point 4
(DAC_TP4) on the inverter side Drive Processor Module (DPM). This is a non-isolated 0-10 V output.

Rockwell Automation PowerFlex 7000 Specifications

General

Brand	Rockwell Automation
Model	PowerFlex 7000
Category	DC Drives
Language	English