Parameter Descriptions 2-135
7000-TD002A-EN-P – September 2007
Local Command Owner [Local Owner]
Linear Number: 386
Access Level: Monitor
Read/Write: Read Only
This parameter specifies which adapters are issuing the local command. A one represents the adapter
that is issuing the local command, a zero represents an adapter that is not issuing the local command.
There are 8 adapters available, from Adapter0 to Adapter7.
Bit Enum Text Description
0 Adapter 0 Host
1 Adapter 1
2 Adapter 2
3 Adapter 3 (Currently unused)
4 Adapter 4 (Currently unused)
5 Adapter 5
6 Adapter 6 (Currently unused)
7 Adapter 7 (Currently unused)
Reference Command Owner [Ref Cmd Owner]
Linear Number: 392
Access Level: Monitor
Read/Write: Read Only
This parameter specifies which adapters are issuing the reference command. A one represents the
adapter that is issuing the reference command, a zero represents an adapter that is not issuing the
reference command. There are 8 adapters available, from Adapter0 to Adapter7.
Bit Enum Text Description
0 Adapter 0 Host
1 Adapter 1
2 Adapter 2
3 Adapter 3 (Currently unused)
4 Adapter 4 (Currently unused)
5 Adapter 5
6 Adapter 6 (Currently unused)
7 Adapter 7 (Currently unused)
Fault Reset Command Owner [Reset Owner]
Linear Number: 391
Access Level: Monitor
Read/Write: Read Only
This parameter specifies which adapters are issuing the reset command. A one represents the adapter
that is issuing the reset command, a zero represents an adapter that is not issuing the reset command.
There are 8 adapters available, from Adapter0 to Adapter7.
Bit Enum Text Description
0 Adapter 0 Host
1 Adapter 1
2 Adapter 2
3 Adapter 3 (Currently unused)
4 Adapter 4 (Currently unused)
5 Adapter 5
6 Adapter 6 (Currently unused)
7 Adapter 7 (Currently unused)
To Next Page
Loading...
