Parameter Descriptions 2-137
7000-TD002A-EN-P – September 2007
Forced Fault Owner [Forced Flt Owner]
Linear Number: 639
Access Level: Monitor
Read/Write: Read Only
This parameter specifies which adapters are issuing the forced fault. A one represents the adapter that is
issuing the forced fault, a zero represents an adapter that is not issuing the forced fault. There are 8
adapters available, from Adapter0 to Adapter7.
Bit Enum Text Description
0 Adapter 0 Host
1 Adapter 1
2 Adapter 2
3 Adapter 3 (Currently unused)
4 Adapter 4 (Currently unused)
5 Adapter 5
6 Adapter 6 (Currently unused)
7 Adapter 7 (Currently unused)
Profile Owner [Profile Owner]
Linear Number: 37
Access Level: Monitor
Read/Write: Read Only
This parameter specifies which adapters are issuing the Acceleration/Deceleration Profile command. A one
represents the adapter that has control over the Acceleration/Deceleration Profile, and a zero represents the
adapters not having control over the Profile. There are 8 adapters available, from Adapter 0 to Adapter 7.
Bit Enum Text Description
0 Adapter 0 Host
1 Adapter 1
2 Adapter 2
3 Adapter 3 (Currently unused)
4 Adapter 4 (Currently unused)
5 Adapter 5
6 Adapter 6 (Currently unused)
7 Adapter 7 (Currently unused)
Logic Owner [Logic Owner]
Linear Number: 94
Access Level: Monitor
Read/Write: Read Only
This parameter specifies which adapters are issuing the Logic command. A one represents the adapter
that is issuing the Logic command, and a zero represents the adapters that are not issuing the Logic
command. There are 8 adapters available, from Adapter 0 to Adapter 7.
Bit Enum Text Description
0 Adapter 0 Host
1 Adapter 1
2 Adapter 2
3 Adapter 3 (Currently unused)
4 Adapter 4 (Currently unused)
5 Adapter 5
6 Adapter 6 (Currently unused)
7 Adapter 7 (Currently unused)
To Next Page
Loading...
Need help?
General
