2-188 Parameter Descriptions
7000-TD002A-EN-P – September 2007
Parallel Drive Flux Reference [PD Flux Ref]
Linear Number: 740
Minimum Value: 0
Maximum Value: 65535
Access Level: Service
Read/Write: Read Only
This variable is the flux reference received from the master. It is raw data, not converted to engineering
units.
Parallel Drive Torque Reference [PD Torq Ref]
Linear Number: 741
Minimum Value: 0
Maximum Value: 65535
Access Level: Service
Read/Write: Read Only
This variable is the torque reference received from the master. It is raw data, not converted to
engineering units.
Parallel Drive Magnetizing Current Command [PD Isd Cmd]
Linear Number: 742
Minimum Value: 0
Maximum Value: 65535
Access Level: Service
Read/Write: Read Only
This variable is the magnetizing current command received from the master. It is raw data, not converted
to engineering units.
Parallel Drive Capacity [PD Capacity]
Linear Number: 746
Minimum Value: 0
Maximum Value: 32767
Access Level: Service
Read/Write: Read Only
This variable is the capacity factor of this drive. It is raw data, not converted to engineering units.
To Next Page
Loading...
