2-186 Parameter Descriptions
7000-TD002A-EN-P – September 2007
Master Flux Reference [Master Flux Ref]
Linear Number: 732
Minimum Value: 0
Maximum Value: 65535
Access Level: Service
Read/Write: Read Only
This variable is the flux reference from the master to all slave drives in a parallel drive system. It is raw
data, not converted to engineering units.
Master Torque Reference [Master Torq Ref]
Linear Number: 733
Minimum Value: 0
Maximum Value: 65535
Access Level: Service
Read/Write: Read Only
This variable is the torque reference from the master to all slave drives in a parallel drive system. It is
raw data, not converted to engineering units.
Master Magnetizing Current Command [Master Isd Cmd]
Linear Number: 734
Minimum Value: 0
Maximum Value: 65535
Access Level: Service
Read/Write: Read Only
This variable is the magnetizing current command from the master to all slave drives in a parallel drive
system. It is raw data, not converted to engineering units.
Master Capacity [Master Capacity]
Linear Number: 737
Minimum Value: 0
Maximum Value: 65535
Access Level: Service
Read/Write: Read Only
This variable is the capacity factor from the master to all slave drives in a parallel drive system. It is raw
data, not converted to engineering units.
To Next Page
Loading...
