2-136 Parameter Descriptions
7000-TD002A-EN-P – September 2007
Start Command Owner [Start Owner]
Linear Number: 387
Access Level: Monitor
Read/Write: Read Only
This parameter specifies which adapters are issuing the start command. A one represents the adapter
that is issuing the start command, a zero represents an adapter that is not issuing the start command.
There are 8 adapters available, from Adapter0 to Adapter7.
Bit Enum Text Description
0 Adapter 0 Host
1 Adapter 1
2 Adapter 2
3 Adapter 3 (Currently unused)
4 Adapter 4 (Currently unused)
5 Adapter 5
6 Adapter 6 (Currently unused)
7 Adapter 7 (Currently unused)
Stop Command Owner [Stop Owner]
Linear Number: 385
Access Level: Monitor
Read/Write: Read Only
This parameter specifies which adapters are issuing the stop command. A one represents the adapter
that is issuing the stop command, a zero represents an adapter that is not issuing the stop command.
There are 8 adapters available, from Adapter0 to Adapter7.
Bit Enum Text Description
0 Adapter 0 Host
1 Adapter 1
2 Adapter 2
3 Adapter 3 (Currently unused)
4 Adapter 4 (Currently unused)
5 Adapter 5
6 Adapter 6 (Currently unused)
7 Adapter 7 (Currently unused)
Synchronous Transfer Command Owner [Sync Xfer Owner]
Linear Number: 393
Access Level: Monitor
Read/Write: Read Only
This parameter specifies which adapters are issuing the synchronous transfer command. A one represents
the adapter that is issuing the synchronous transfer command, a zero represents an adapter that is not
issuing the synchronous transfer command. There are 8 adapters available, from Adapter0 to Adapter7.
Bit Enum Text Description
0 Adapter 0 Host
1 Adapter 1
2 Adapter 2
3 Adapter 3 (Currently unused)
4 Adapter 4 (Currently unused)
5 Adapter 5
6 Adapter 6 (Currently unused)
7 Adapter 7 (Currently unused)
To Next Page
Loading...
Need help?
General
