2-168 Parameter Descriptions
7000-TD002A-EN-P – September 2007
Control Power 24V Hall Effect Current Sensor [Control HECS]
Linear Number: 156
Minimum Value: 0.0 V
Maximum Value: 36.0 V
Access Level: Advanced
Read/Write: Read Only
This parameter displays the measured value of 24V output from the DC/DC converter to the Current
sensors (HECS).
Control Power Redundant 5V [Control 5V Redn]
Linear Number: 237
Minimum Value: 0.0 V
Maximum Value: 8.0 V
Access Level: Advanced
Read/Write: Read Only
This parameter displays the measured value of the redundant 5V output from the DC/DC converter.
IGDPS 56V [IGDPS 56V]
Linear Number: 101
Minimum Value: 0.0 V
Maximum Value: 72.0 V
Access Level: Advanced
Read/Write: Read Only
This parameter displays the measured value of the 56V output from the AC/DC power supply to the
Isolated Gate Driver Power Supply (IGDPS). When an UPS is not installed in the drive, this parameter is
same as control voltage indicated by Control 56V (121).
Control Power 24V XIO [Control XIO]
Linear Number: 196
Minimum Value: 0.0 V
Maximum Value: 36.0 V
Access Level: Advanced
Read/Write: Read Only
This parameter displays the measured value of the 24V output from the DC/DC converter to the XIO
board.
To Next Page
Loading...
Need help?
General
