Rockwell Automation PowerFlex 7000 - Page 250

2-206 Parameters Listed by Group
7000-TD002A-EN-P – September 2007
Speed Command Parameters
Name Min. Max. Default Units
Read-
Only
Access
277 Speed Command -120.0 120.0 - Hz Y Basic
276 Speed Command In -120.0 120.0 - Hz Y Basic
275 Control Refernce 0.0 6553.5 - Hz Y Basic
273 Control Feedback 0.0 6553.5 - Hz Y Basic
47 SpdCmd Pot -120.0 120.0 - Hz Y Basic
48 SpdCmd Anlg Inp1 -120.0 120.0 - Hz Y Basic
56 SpdCmd Anlg Inp2 -120.0 120.0 - Hz Y Basic
58 SpdCmd DPI -120.0 120.0 - Hz Y Basic
59 SpdCmd PID -120.0 120.0 - Hz Y Basic
293 Speed Cmd Min 0.0 120.0 6.0 Hz N Basic
290 Speed Cmd Max 0.0 120.0 60.0 Hz N Basic
41 RefCmd Pot Min -120.0 120.0 6.0 Hz N Basic
42 RefCmd Pot Max 0.0 120.0 60.0 Hz N Basic
43 RefCmdAnlgInpMin -120.0 120.0 6.0 Hz N Basic
44 RefCmdAnlgInpMax 0.0 120.0 60.0 Hz N Basic
45 RefCmd DPI Min 0.0 120.0 6.0 Hz N Basic
46 RefCmd DPI Max 0.0 120.0 60.0 Hz N Basic
40 Preset Jog Speed 1.0 60.0 6.0 Hz N Basic
33 Preset Speed 1 0.5 75.0 30.0 Hz N Advanced
34 Preset Speed 2 0.5 75.0 35.0 Hz N Advanced
35 Preset Speed 3 0.5 75.0 40.0 Hz N Advanced
Speed Control Parameters
Name Min. Max. Default Units
Read-
Only
Access
278 Speed Reference -120.0 120.0 - Hz Y Monitor
289 Speed Feedback -120.0 120.0 - Hz Y Monitor
472 Speed Error -10.00 10.00 - Hz Y Advanced
292 MtrTorque CurCmd -4.000 4.000 - pu Y Advanced
294 InvTorque CurCmd -4.000 4.000 - pu Y Advanced
61 Total Accel Time 0.0 1200.0 32.0 sec N Monitor
62 Total Decel Time 0.0 1200.0 32.0 sec N Monitor
63 Inertia Type - - Low N Basic
82 Total Inertia 0.10 50.00 1.00 sec N Advanced
89 Speed Fbk Mode - - Sensorless N Advanced
81 SpdReg Bandwidth 0.1 15.0 1.0 r/s N Advanced
88 Speed Ref Step 0.0 2.0 0.0 Hz N Service