Rohde & Schwarz FSVA - Page 775

Remote Control
R&S
®
FSVA/FSV
775Operating Manual 1176.7510.02 ─ 09
PROBe:SETup:MODE <Mode>
This command defines which action is taken when the probe's micro button is pressed.
Parameters:
<Mode> RSINgle
A single sweep is performed.
NOACtion
No action is taken.
*RST: OFF
Example:
PROB:SET:STAT ON
Manual operation: See "Probe Config" on page 429
See "Micro Button Action" on page 434
PROBe:SETup:NAME?
This command returns the name of the connected probe.
Example:
PROB:SET:NAME?
Usage: Query only
Manual operation: See "Name" on page 434
PROBe:SETup:STATe?
This command queries whether a probe is connected to the instrument's RF INPUT
and USB connectors and was recognized by the R&S FSVA/FSV.
Example:
PROB:SET:STAT ON
Usage: Query only
PROBe[:STATe] <State>
This command activates a connected probe. Use this command to switch off the probe
and measure the digital input without considering the transducer factor of the probe.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
PROB:STAT ON
Manual operation: See "Probe Config" on page 429
See "State" on page 434
Remote Control – Commands