Rohde & Schwarz FSVA - Page 801

Remote Control
R&S
®
FSVA/FSV
801Operating Manual 1176.7510.02 ─ 09
[SENSe:]ESPectrum:RANGe<range>:LIMit<source>:ABSolute:STARt <Level>
This command sets an absolute limit value at the start frequency of the specified
range. Different from manual operation, this setting is independently of the defined limit
check type.
Suffix:
<range>
.
1...20
range
Parameters:
<Level> -400 to in 400 dBm
*RST: 13 dBm
Example:
ESP:RANG1:LIM:ABS:STAR 10
Sets an absolute limit of 10 dBm at the start frequency of the
range.
Manual operation: See "Abs Limit Start" on page 349
[SENSe:]ESPectrum:RANGe<range>:LIMit<source>:ABSolute:STOP
<Level>
This command sets an absolute limit value at the stop frequency of the specified
range. Different from manual operation, this setting is independent of the defined limit
check type.
Suffix:
<range>
.
1...20
range
Parameters:
<Level> -400 to in 400 dBm
*RST: 13 dBm
Example:
ESP:RANG1:LIM:ABS:STOP 20
Sets an absolute limit of 20 dBm at the stop frequency of the
range.
Manual operation: See "Abs Limit Stop" on page 349
[SENSe:]ESPectrum:RANGe<range>:LIMit<source>:RELative:STARt <Limit>
This command sets a relative limit value at the start frequency of the specified range.
Different from manual operation, this setting is independent of the defined limit check
type.
Suffix:
<range>
.
1...20
range
Parameters:
<Limit> -400 to in 400 dBc
*RST: -50 dBc
Remote Control – Commands