Rohde & Schwarz SMB100A - Gui Update

Instrument Function
R&S
®
SMB100A
86Operating Manual 1407.0806.32 ─ 13
License Registration
If your purchased license is delivered unregistered, you must register it before you can
activate the option.
For detailed information about the license registration, refer to the installation instructions
provided with the option (Supplement A) and the documentation of the online tool "Man-
age Licenses" (https://extranet.rohde-schwarz.com/service).
Only if the R&S Signal Generator is equipped with an older firmware version, a firmware
update prior to enabling the software option may be required. The information on the valid
firmware versions for the purchased software option is provided together with the option.
The firmware update is described in the service manual, chapter 4 (on CD ROM, supplied
with the instrument).
Device ID
Displays the instrument specific identification number. The device ID is an unique string
with the following structure:
<stock number>-<serial number>-<checksum>
Enter License Key
Type here the license key provided with the option.
For license keys delivered as a file, use Import License Key from File....
Import License Key from File...
Opens a dialog for selecting the file with the license key.
Export Deactivation Response to File...
Exports the generated deactivation response key to a file and opens a file management
dialog to save the file. This key is required during the unregistration process.
Status Information
Displays status information.
5.2.3.5 Gui Update
The "Start/Stop Gui Update" dialog provides the possibility to switch off update of the
displayed parameters in order to increase speed for certain settings.
The indicated values are not updated and may therefore differ from the intern, used val-
ues.
General Instrument Settings