Instrument Function
R&S
®
SMB100A
101Operating Manual 1407.0806.32 ─ 13
If this parameter is disabled, the instrument cannot be manually controlled but changes
in the settings are shown on the display. Remote access and remote control are enabled.
The setting requires the entry of the security password and is only accepted after the
"Accept" button is pressed.
To enable the keyboard, type the security password on the external keyboard or use the
SYST:KLOC OFF command over remote control.
Remote command:
:SYSTem:KLOCk on page 395
Security Password
Enters the password that is required to enable or to disable the settings protected by a
security password. Default is '123456'.
Note: It is highly recommended to change the default security password before connect-
ing the instrument to the network.
All settings are only accepted after the "Accept" button is pressed.
Remote command:
n.a.
Accept - Security
Accepts a new entry or selection and changes the settings accordingly.
Remote command:
n.a.
Bluetooth Pin
Requires a USB Bluetooth adapter (recommended extra, see data sheet).
Enters the Bluetooth pin of an external Bluetooth device. The pin is required to enable
remote control via an external Bluetooth device.
Remote command:
n.a.
5.2.3.16 Save/Recall
The "Save/Recall" submenu can also be called up with the FILE key and is therefore
described in the section of this key (see chapter 5.2.8, "Storing and Loading Instrument
Data - File Key", on page 107).
5.2.3.17 Factory Preset
The "Factory Preset" dialog provides a function to reset the instrument's settings to their
factory state. This function is activated by pressing the "Execute Factory Preset" button.
General Instrument Settings
To Next Page
Loading...
