Rohde & Schwarz SMB100A - S Ystem: D Isplay: U Pdate; S Ystem: P Rotect<Ch>[: S Tate]; System:startup:complete

Remote Control Commands
R&S
®
SMB100A
402Operating Manual 1407.0806.32 ─ 13
:SYSTem:PROTect<ch>[:STATe] <State>[, <Key>]
Activates/deactivates the specified protection level.
Parameters:
<State> select
*RST: 1
Setting parameters:
<Key> integer
The respective functions are disabled when the protection level is
activated. No password is required for activation. A password must
be entered to deactivate the protection level. The password for the
first level is 123456. This protection level can be used to lock-out
internal adjustments.
Example:
SYST:PROT1 ON
activates protection level 1. Internal adjustments are only possible
after deactivating the lock-out.
SYST:PROT1 OFF, 123456
deactivates protection level 1. Internal adjustments are enabled
again.
Manual operation: See "Protection Level/Password" on page 97
:SYSTem:STARtup:COMPlete?
Queries if the startup of the instrument is completed.
Return values:
<Complete> 0 | 1 | OFF | ON
*RST: 0
Example:
SYST:STAR:COMP
Response: 1
The startup of the instrument is completed.
Usage: Query only
:SYSTem:DISPlay:UPDate <Update>
The command switches the update of the display on/off. A switchover from remote control
to manual control always sets the status of the update of the display to ON.
Parameters:
<Update> 0 | 1 | OFF | ON
*RST: ON
Example:
SYST:DISP:UPD OFF
switches update of displayed parameter values off.
Manual operation: See "On/Off GUI Update" on page 87
SYSTem Subsystem