Rohde & Schwarz SMB100A - S Ystem: C Ommunicate: G PIB: L Terminator; S Ystem: D Lock; S Ystem: K Lock

Remote Control Commands
R&S
®
SMB100A
395Operating Manual 1407.0806.32 ─ 13
Example:
SYST:SERR?
queries all errors existing in the error queue.
Response: -221, 'Settings conflict', 153, 'Input
voltage out of range'
the two returned errors have occurred since the error queue was
last queried.
Usage: Query only
:SYSTem:DLOCk <DispLockStat>
This command (Display LOCk) disables the manual operation via the display, or enables
it again (OFF).
The command disables also the front panel keyboard of the instrument including the
LOCAL key.
Parameters:
<DispLockStat> 0 | 1 | OFF | ON
*RST: 0
Example:
SYST:DLOC ON
activates the display lock. The instrument cannot be operated via
the display until it has been enabled with SYST:DLOC OFF.
Manual operation: See "Display" on page 100
:SYSTem:KLOCk <State>
This command (Keyboard LOCk) disables the front panel keyboard of the instrument
including the LOCAL key, or enables it again (OFF).
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
SYST:KLOC ON
activates the keyboard lock. The keyboard cannot be operated
again until it has been enabled with SYST:KLOC OFF.
Manual operation: See "Keyboard" on page 100
:SYSTem:COMMunicate:GPIB:LTERminator <LTerminator>
The command sets the terminator recognition for remote control via GPIB bus.
SYSTem Subsystem