Remote Control Commands
R&S
®
SMB100A
283Operating Manual 1407.0806.32 ─ 13
Example:
SENS1:FILT:TYPE NSR
selects fixed noise filter mode for the power sensor connected to
the SENSOR connector.
SENS1:FILT:NSR .2
sets a noise content of 0.2.
SENS1:FILT:NSR:MTIM 5
limits the settling time to 5 seconds
Manual operation: See "Filter Length - Power Sensors" on page 145
:SENSe<ch>[:POWer]:FILTer:SONCe
The command activates the search for the optimum filter length for the current measure-
ment conditions. The found filter length can be retrieved with com-
mand :SENSe:POWer:FILTer:LENGth:USER?. This command is only available for
user filter mode (:SENSe:POWer:FILTer:TYPE USER).
Example:
SENS:FILT:TYPE USER
selects user filter mode.
SENS:FILT:SONC
activates the search for the optimum filter length.
SENS:FILT:LENG?
returns the found optimum filter length.
Response: 128
Usage: Event
Manual operation: See "Auto Once" on page 145
:SENSe<ch>[:POWer]:FILTer:TYPE <Type>
The command selects the filter mode. The filter length is the multiplier for the time window
and thus directly influences the measurement time.
SENSe, READ and INITiate Subsystems
To Next Page
Loading...
