Instrument Function
R&S
®
SMB100A
97Operating Manual 1407.0806.32 ─ 13
Protection Level/Password
Protection Level 1 can be activated to expand the functionality of the internal adjustment
and to access the selftests.
The password is 123456.
For access to service functions of protection level 2, see the service manual of your R&S
SMB.
Remote command:
:SYSTem:PROTect<ch>[:STATe] on page 402
5.2.3.15 Security
The "Security" dialog provides access to the passwords and mass storage security set-
tings. To open this menu, use the SETUP or MENU key under "Protection".
The menu is divided into the password sections and the security settings section. In the
password section, the passwords for securing a controlled access to the instrument are
defined and changed.
A change of passwords for the operating system and security password requires the entry
of the old and new password and the conformation of the new password. All settings are
only accepted after the "Change Password" button is pressed.
User Name
Indicates the user name used for access to the Linux operating system and valid for VNC,
FTP and SAMBA access.
General Instrument Settings
To Next Page
Loading...
